ProCom Dual Fuel Ventless Gas Fireplace System with Mantle

pengenalan

This manual provides detailed instructions for the safe installation, operation, and maintenance of your ProCom Dual Fuel Ventless Gas Fireplace System with Mantle. This system is designed to operate efficiently using either Natural Gas (NG) or Liquid Propane (LP) and features a thermostat control for consistent heating. Please read all instructions carefully before installation and use.

Imej: Depan view of the ProCom Dual Fuel Ventless Gas Fireplace System in Antique White, showcasing the mantle and the firebox with realistic logs and flames.

Maklumat Keselamatan

AMARAN: Pemasangan, pelarasan, pengubahan, servis atau penyelenggaraan yang tidak betul boleh menyebabkan kecederaan atau kerosakan harta benda. Rujuk manual ini. Untuk mendapatkan bantuan atau maklumat tambahan, rujuk pemasang yang berkelayakan, agensi perkhidmatan atau pembekal gas.

• Perkakas ini adalah untuk kegunaan dalaman sahaja.
• Jangan simpan atau gunakan petrol atau wap dan cecair mudah terbakar lain di sekitar ini atau mana-mana perkakas lain.
• Disebabkan oleh suhu yang tinggi, perkakas harus diletakkan di luar lalu lintas dan jauh dari perabot dan langsir.
• Kanak-kanak dan orang dewasa harus dimaklumkan tentang bahaya suhu permukaan yang tinggi dan harus menjauhkan diri untuk mengelakkan terbakar atau pakaian tercucuh.
• Kanak-kanak kecil harus diawasi dengan teliti ketika mereka berada di ruangan yang sama dengan perkakas.
• Jangan letakkan pakaian atau bahan mudah terbakar lain pada atau berhampiran perkakas.
• This appliance is equipped with an Oxygen Depletion Sensor (ODS) safety system. Do not attempt to bypass or tamper with the ODS.
• Ensure adequate ventilation as specified in the installation instructions.

Persediaan dan Pemasangan

Membongkar dan Pemeriksaan

Carefully remove all components from the packaging. Inspect for any shipping damage. If any damage is found, contact your retailer immediately. Ensure all parts listed in the "What's in the Box" section are present.

• Ventless Fireplace Insert - Qty. 1
• Ceramic Fiber Log Set - Qty. 1 (4 realistic hand painted Concrete Logs)
• Hardware Pack - Qty. 1
• Fireplace Mantel (Antique White Furniture Grade Finish) - Qty. 1

Perhimpunan

Some assembly is required for the mantle and the fireplace insert. Refer to the general assembly instructions provided with the product. Ensure the fireplace insert is securely placed within the mantle.

Image: The ProCom fireplace system integrated into a living room setting, demonstrating its aesthetic appeal.

Fuel Type Selection (Dual Fuel Technology)

This fireplace system is designed for use with either Natural Gas (NG) or Liquid Propane (LP). It is crucial to select the correct fuel type and ensure the appliance is configured accordingly before connecting to a gas supply.

Penting: Conversion between NG and LP must be performed by a qualified service technician. Incorrect conversion can lead to unsafe operation and void the warranty.

Image: Close-up of the gas inlet ports, labeled NG (Natural Gas) and LP (Liquid Propane), showing the blue cap for LP. This indicates the current configuration or the port for LP connection.

Image: Close-up of the gas inlet ports, labeled NG (Natural Gas) and LP (Liquid Propane), showing both yellow and blue caps. This illustrates the dual fuel capability and the distinct caps for each gas type.

Sambungan Gas

Connect the fireplace to the appropriate gas supply (Natural Gas or Liquid Propane) using approved gas connectors and fittings. Ensure all connections are tight and leak-free. A gas pressure test must be performed by a qualified technician.

• Maximum inlet gas pressure: 1/2 PSIG (3.5 kPa).

Arahan Operasi

Permulaan Awal

1. Pastikan injap bekalan gas terbuka.
2. Press and hold the control knob (refer to image below) to the "PILOT" position.
3. While holding the knob, press the Piezo ignitor button repeatedly until the pilot flame ignites.
4. Continue to hold the control knob for approximately 30-60 seconds after the pilot ignites to allow the thermocouple to heat up.
5. Release the control knob. If the pilot flame extinguishes, repeat steps 2-4.

Image: Close-up of the control panel showing the main control knob with settings for "OFF", "PILOT", and numbered temperature settings (1-5), alongside the Piezo ignitor button.

Thermostat Control Operation

Once the pilot is lit, turn the control knob to the desired temperature setting (1-5). The thermostat will automatically cycle the main burner on and off to maintain the set room temperature. Setting 1 is the lowest heat output, and setting 5 is the highest.

• 15,000 BTU Maximum Output: Memanaskan sehingga 600 kaki persegi.
• 99.9% Efficient: Provides economical supplemental heat.

Shutting Down the Fireplace

1. To turn off the main burner, turn the control knob to the "PILOT" position. The pilot flame will remain lit.
2. To completely turn off the fireplace, turn the control knob to the "OFF" position. This will extinguish both the main burner and the pilot flame.
3. For extended periods of non-use, it is recommended to close the main gas supply valve.

Penyelenggaraan

Pembersihan Am

• Pastikan kawasan perkakas bersih dan bebas daripada bahan mudah terbakar, petrol, dan wap dan cecair mudah terbakar lain.
• Periodically clean the exterior surfaces of the mantle with a soft, damp kain. Elakkan pembersih yang kasar.
• Ensure the air openings of the appliance are not obstructed.

Log Set Care

The ceramic fiber logs are designed for durability. Handle them carefully to avoid breakage. Do not rearrange the logs from their factory-set positions, as this can affect flame appearance and efficiency.

Pemeriksaan Tahunan

It is recommended to have the fireplace inspected annually by a qualified service technician to ensure proper operation and safety.

Menyelesaikan masalah

If troubleshooting steps do not resolve the issue, contact a qualified service technician or ProCom customer support.

Spesifikasi

Maklumat Waranti

This ProCom Dual Fuel Ventless Gas Fireplace System is covered by a Waranti Terhad 1 Tahun. For specific terms and conditions, please refer to the warranty documentation included with your product or contact ProCom customer support.

Sokongan Pelanggan

For technical assistance, parts, or warranty claims, please contact ProCom customer support. Have your model number (PCS150T-1-AW) and purchase date available when contacting support.

Pengeluar: ProCom

Refer to the product packaging or the official ProCom webtapak untuk maklumat hubungan terkini.