pengenalan
Thank you for choosing the Intex PureSpa Plus 28431E Portable Inflatable Hot Tub Spa. This manual provides essential information for the safe and efficient setup, operation, and maintenance of your spa. Please read all instructions carefully before installation and use to ensure proper function and longevity of your product.
Maklumat Keselamatan
Arahan Keselamatan Penting: Apabila memasang dan menggunakan peralatan elektrik ini, langkah berjaga-jaga keselamatan asas hendaklah sentiasa dipatuhi, termasuk yang berikut:
- Baca dan ikut semua arahan.
- Jangan benarkan kanak-kanak menggunakan produk ini melainkan mereka diawasi dengan rapi pada setiap masa.
- A green colored terminal or a terminal marked G, GR, Ground, Grounding or the grounding symbol is located inside the supply terminal box. To reduce the risk of electric shock, this terminal must be connected to the grounding means provided in the electric supply service panel with a continuous copper wire equivalent in size to the circuit conductors supplying this equipment.
- At least two pressure wire connectors marked “BONDING LUGS” are provided on the external surface or inside the electrical compartment. To reduce the risk of electric shock, connect the local common bonding grid in the area of the spa to these terminals with an insulated or bare copper conductor not smaller than No. 8 AWG (8.4 mm²).
- All field-installed metal components such as rails, ladders, drains, or other similar hardware within 3 meters (10 feet) of the spa shall be bonded to the equipment grounding conductor of the spa in accordance with local requirements.
- AMARAN: Untuk mengurangkan risiko kecederaan, jangan benarkan kanak-kanak menggunakan produk ini melainkan mereka diawasi dengan rapi pada setiap masa.
- AMARAN: The spa water temperature should never exceed 40°C (104°F). Water temperatures between 38°C (100°F) and 40°C (104°F) are considered safe for a healthy adult. Lower water temperatures are recommended for young children and when spa use exceeds 10 minutes.
- AMARAN: Pregnant women and persons with heart disease, high blood pressure, diabetes, or other health conditions should consult a physician before using a spa.
- AMARAN: To avoid injury, exercise care when entering or exiting the spa.
- AMARAN: Do not use a spa immediately following strenuous exercise.
- AMARAN: Prolonged immersion in a spa may be hazardous to your health.
- AMARAN: Do not use drugs or alcohol before or during spa use to avoid unconsciousness and possible drowning.
- AMARAN: Always disconnect this product from the electrical supply before removing, cleaning, servicing or making any adjustment to the product.
- AMARAN: Produk ini tidak bertujuan untuk kegunaan komersial.
- AMARAN: This product is not intended for use by persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the product by a person responsible for their safety.
Arahan Persediaan
Proper setup is crucial for the performance and safety of your Intex PureSpa Plus. Follow these steps carefully.
1. Pemilihan dan Penyediaan Tapak
Choose a flat, level surface free of sharp objects. Ensure the area can support the weight of the filled spa (approximately 290 gallons of water plus occupants). A ground cloth is recommended to protect the spa bottom.
2. Inflasi
Unfold the spa liner and place it on the prepared ground cloth. Connect the inflation hose to the spa's air valve and the pump's inflation port. Inflate the spa until it is firm to the touch but not over-inflated. Do not use an air compressor for inflation.
3. Control Unit Connection
Connect the control unit to the spa liner following the instructions in the manual. Ensure all connections are secure. Plug the control unit into a grounded electrical outlet. Do not use extension cords.
4. Isi Air
Fill the spa with fresh water using a garden hose. Fill to the recommended water level indicated on the spa liner. Do not overfill.
5. Filter Cartridge Installation
Install the filter cartridges into the filter housing inside the spa. Ensure they are properly seated and secured.
Arahan Operasi
Familiarize yourself with the control panel to operate your spa effectively.
1. Hidupkan/Mati Kuasa
Press the power button on the control panel to turn the spa on or off.
2. Sistem Pemanasan
Press the heater button to activate the heating system. Use the temperature adjustment buttons to set your desired water temperature (68-104°F / 20-40°C). The heater will automatically turn off once the set temperature is reached and restart if the temperature drops.
3. Bubble Jets
Activate the 170 high-powered bubble jets by pressing the bubble button. The bubble function provides a relaxing massage. Note that running the bubble jets may slightly decrease water temperature.
4. Operasi Lampu LED
The spa includes a multi-colored LED light. Refer to the control panel for specific buttons to cycle through colors or set a preferred lighting mode.
Penyelenggaraan
Regular maintenance ensures optimal performance and extends the life of your spa.
1. Pembersihan dan Penggantian Kartrij Penapis
Check and clean the filter cartridges regularly, ideally after each use or every few days depending on usage. Rinse them with a garden hose. Replace cartridges every 2-4 weeks or when they remain dirty after cleaning.
2. Water Treatment
The spa is equipped with a built-in hard water treatment system. However, regular water chemistry maintenance is essential. Test the water pH and sanitizer levels (e.g., chlorine) frequently and adjust as needed using appropriate spa chemicals. Maintain pH between 7.4 and 7.6.
3. Pengeringan dan Penyimpanan
When not in use for extended periods or for seasonal storage, drain the spa completely. Clean and dry the spa thoroughly before deflating and storing it in a cool, dry place. Use the included carry bag for easy transport and storage.
Menyelesaikan masalah
This section addresses common issues you might encounter with your Intex PureSpa Plus.
| Masalah | Kemungkinan Punca | Penyelesaian |
|---|---|---|
| Spa tidak dipanaskan | Heater not activated, low water level, dirty filter, ambient temperature too low. | Ensure heater is on. Check water level and add water if necessary. Clean or replace filter cartridge. Ensure outdoor temperature is above 50°F (10°C) for optimal heating. |
| Pancutan gelembung tidak berfungsi | Bubble function not activated, air pump malfunction. | Press the bubble button on the control panel. Check power supply to the control unit. If issue persists, contact customer support. |
| Air keruh | Dirty filter, improper water chemistry, high bather load. | Clean or replace filter cartridge. Test and adjust water chemistry (pH, sanitizer). Shock the water if necessary. Reduce bather load. |
| Spa is deflating | Air valve not closed properly, puncture in liner. | Ensure air valve is securely closed. Inspect liner for punctures and repair using the provided patch kit. |
Spesifikasi
Detailed technical specifications for the Intex PureSpa Plus Model 28431E.
| Ciri | Spesifikasi |
|---|---|
| Nama Model | 28431E |
| Jenama | Intex |
| warna | Biru Laut |
| Dimensi Produk (Melambung) | 85"L x 85"W x 28"H (Inner/Outer Diameter: 65in / 85in) |
| bahan | Polyvinyl Chloride (PVC) with Fiber-Tech Construction |
| Kapasiti Air | 290 gelen |
| Kapasiti Tempat Duduk | 6 orang |
| Number of Bubble Jets | 170 |
| Voltage | 110 Volt |
| Julat Suhu Air | 68-104°F (20-40°C) |
| Ciri Khas | Built-in hard water treatment system, multi-colored LED light, 2 contoured headrests, puncture-resistant three-ply laminated material. |
| Berat Barang | 110.3 paun |
| UPC | 078257284313 |
Waranti dan Sokongan
Untuk maklumat jaminan, sila rujuk dokumentasi yang disertakan dengan produk anda atau lawati laman web rasmi Intex website. If you require assistance with setup, operation, maintenance, or troubleshooting, please contact Intex customer support. Keep your purchase receipt and model number handy when contacting support.
Sokongan Pelanggan: For further assistance, please visit the Intex customer support portal or contact their service line as provided in your product packaging.
