Fiamma 98655-121

Fiamma F45 Plus End Stop Device User Manual

Model: 98655-121

Jenama: Fiamma

pengenalan

This manual provides essential information for the proper installation, operation, and maintenance of the Fiamma 98655-121 F45 Plus End Stop Device. This component is designed as a replacement part for Fiamma F45 awnings, specifically for models ranging from 2.5 to 3.5 meters in length. Please read this manual thoroughly before attempting any procedures.

Maklumat Keselamatan

  • Sentiasa pakai peralatan pelindung diri (PPE) yang sesuai seperti sarung tangan dan pelindung mata semasa pemasangan atau penyelenggaraan.
  • Ensure the awning is fully retracted and secured before beginning any work on the end stop device.
  • If you are unsure about any step, consult a qualified technician or refer to the complete awning manual.
  • Jauhkan bahagian kecil daripada kanak-kanak.

Kandungan Pakej

The package contains one Fiamma 98655-121 F45 Plus End Stop Device. Please verify all components are present and undamaged upon opening the package.

Fiamma 98655-121 F45 Plus End Stop Device

Rajah 1: The Fiamma 98655-121 F45 Plus End Stop Device. This image shows the blue plastic housing, the metal shaft, and the internal spring mechanism.

Persediaan dan Pemasangan

This section outlines the general steps for replacing or installing the end stop device. Specific procedures may vary slightly depending on your awning model. Refer to your awning's primary instruction manual for detailed installation steps.

  1. Penyediaan: Ensure the awning is fully closed and secured. Disconnect any power supply if it's an electric awning.
  2. Akses: Carefully access the end of the awning where the end stop device is located. This may involve removing an end cap or cover.
  3. Pembuangan (jika diganti): Identify how the existing end stop device is secured (e.g., screws, clips). Carefully remove it, noting its orientation.
  4. Pemasangan: Insert the new Fiamma 98655-121 end stop device into position. Ensure it is correctly aligned and seated.
  5. selamat: Fasten the new device using the appropriate hardware (not included with this part, typically reused from the original installation).
  6. Pasang semula: Replace any covers or end caps that were removed.
  7. Ujian: Slowly extend and retract the awning a few times to ensure the new end stop device functions correctly and the awning stops at the appropriate points.

Mengendalikan Peranti

The Fiamma 98655-121 F45 Plus End Stop Device is a passive component designed to limit the extension and retraction of your Fiamma F45 awning. It works in conjunction with the awning's internal mechanisms to ensure the awning stops at its fully extended and fully retracted positions, preventing over-extension or over-retraction that could damage the awning or its components. No direct user operation is required for this specific device once installed correctly.

Penyelenggaraan

Regular inspection of the end stop device can help ensure the longevity and proper function of your awning.

  • Pemeriksaan Visual: Periodically inspect the end stop device for any signs of wear, cracks, or damage.
  • Pembersihan: If necessary, gently clean the device with a soft, damp kain untuk menghilangkan kotoran atau serpihan. Elakkan menggunakan bahan kimia yang keras atau pembersih yang kasar.
  • Semakan Fungsi: During awning operation, observe that the awning consistently stops at its intended limits. If it over-extends or over-retracts, the end stop device or other awning components may require attention.

Menyelesaikan masalah

MasalahKemungkinan PuncaPenyelesaian
Awning over-extends or over-retracts.Damaged or worn end stop device. Incorrect installation.Inspect the end stop device for damage and replace if necessary. Verify correct installation as per the awning's manual.
Device does not fit.Model yang dibeli salah.Verify the model number (98655-121) against your awning's requirements. This device is for Fiamma F45 Plus awnings 2.5-3.5M.

Spesifikasi

AtributPerincian
Nombor Model98655-121
JenamaFiamma
Berat Barang7.4 auns
Dimensi Produk4.96 x 2.56 x 2.13 inci (lebih kurang 12.6 x 6.5 x 5.4 cm)
KeserasianFiamma F45 Plus Awnings (2.5-3.5M)
Jenis AngkatManual (refers to awning operation, not the device itself)
Fiamma 98655-121 F45 Plus End Stop Device with dimensions

Rajah 2: Dimensions of the Fiamma 98655-121 End Stop Device, showing a length of approximately 4.9 inches (12 cm).

Waranti dan Sokongan

Information regarding the specific warranty for the Fiamma 98655-121 F45 Plus End Stop Device is not provided in this document. Please refer to the original purchase documentation or contact Fiamma customer support for warranty details and technical assistance.

For further support, visit the official Fiamma webtapak atau hubungi bahagian perkhidmatan pelanggan mereka. Visit Fiamma Official Webtapak

Dokumen Berkaitan - 98655-121

Praview Bilik Privasi Fiamma F45 Panduan Pemasangan dan Penggunaan
Arahan komprehensif untuk memasang dan menggunakan kandang awning Bilik Privasi Fiamma F45, termasuk senarai bahagian, langkah pemasangan, penyelenggaraan dan maklumat waranti.
Praview Panduan Pemasangan dan Penggunaan Kit Lampu LED Fiamma Rafter
Panduan komprehensif untuk memasang dan menggunakan kit lampu LED Fiamma Rafter untuk kenderaan rekreasi. Termasuk arahan keselamatan, senarai bahagian dan maklumat waranti.
Praview Panduan Pemasangan dan Penggunaan Teduhan Fiamma Side W Pro & Side W Pro
Panduan ini menyediakan arahan pemasangan, penggunaan dan penyelenggaraan yang terperinci untuk aksesori awning Side W Pro dan Side W Pro Shade Fiamma, direka bentuk untuk meningkatkan ruang kediaman luaran.
Praview Panduan Pemasangan LED Fiamma Rafter dan Maklumat Produk
Panduan pemasangan yang komprehensif dan butiran produk untuk sistem pencahayaan LED Fiamma Rafter, direka untuk kenderaan rekreasi. Termasuk keselamatan, jaminan dan spesifikasi teknikal.
Praview Panduan Pemasangan dan Penggunaan Kit Lampu LED FIAMMA
Arahan pemasangan dan penggunaan yang komprehensif untuk kit lampu LED FIAMMA, termasuk garis panduan keselamatan, spesifikasi teknikal, kandungan pakej, maklumat waranti dan Pengisytiharan Pematuhan EU.
Praview Panduan Pemasangan Penyesuai Fiamma LMC-TEC untuk Awning F65/F80
Arahan pemasangan yang komprehensif untuk penyesuai Fiamma LMC-TEC, direka untuk awning F65 dan F80. Termasuk senarai alat ganti, pemasangan langkah demi langkah, langkah berjaga-jaga keselamatan dan maklumat waranti.