1. Pengenalan
The CyberPower BRG1500AVRLCD Intelligent LCD UPS System is designed to provide reliable battery backup and surge protection for desktop computers, workstations, networking devices, and home entertainment systems. This Uninterruptible Power Supply (UPS) system utilizes line interactive topology and simulated sine wave output to safeguard your valuable electronics from power interruptions and fluctuations.
Key features include Automatic Voltage Regulation (AVR) to correct minor power fluctuations without switching to battery power, thereby extending battery life. It also offers two USB charge ports (2.1 Amps shared) for portable devices.
Figure 1: CyberPower BRG1500AVRLCD UPS System in a typical office environment, providing power protection to connected devices.
2. Langkah-langkah Keselamatan
Sila baca dan ikuti semua arahan keselamatan dengan teliti sebelum memasang atau mengendalikan UPS. Kegagalan berbuat demikian boleh mengakibatkan kerosakan pada unit, peralatan yang disambungkan atau kecederaan diri.
- Do not install the UPS in direct sunlight, near heat-emitting appliances, or in areas with excessive humidity.
- Ensure the UPS is connected to a grounded outlet.
- Jangan buka UPS casing. There are no user-serviceable parts inside. Refer servicing to qualified service personnel.
- Jangan gunakan UPS untuk peralatan perubatan atau sokongan hayat.
- Ensure proper ventilation around the UPS. Do not block any ventilation openings.
- In case of fire, use a powder fire extinguisher. Do not use water.
3. Kandungan Pakej
Sahkan bahawa semua item terdapat dalam pakej:
- Unit UPS
- Manual Pengguna
4. Produk Lebihview
4.1 Panel Depan
Rajah 2: Depan view of the CyberPower BRG1500AVRLCD UPS, highlighting the Intelligent LCD panel and USB charging ports.
The front panel features the Intelligent LCD display, control buttons (Display, Mute, Enter, Setup), and two USB charge ports (USB-A and USB-C) for convenient charging of portable devices.
4.2 Panel Belakang
Rajah 3: Belakang view of the CyberPower BRG1500AVRLCD UPS, detailing the NEMA 5-15R outlets, network, cable, and serial ports.
The rear panel includes 12 NEMA 5-15R outlets: six battery backup & surge protected outlets and six surge protected outlets. It also features network (RJ45) and cable (Coax) surge protection ports, a serial port, and a USB port for management software connectivity. A circuit breaker reset button is also located on the rear panel.
5. Persediaan
5.1 Pengecasan Awal
Before initial use, plug the UPS into a grounded wall outlet and allow it to charge for at least 8 hours to ensure maximum battery runtime. The unit will automatically turn on when connected to mains power.
5.2 Peralatan Penyambung
- Sandaran Bateri & Saluran Keluar Dilindungi Lonjakan: Sambungkan peralatan kritikal seperti komputer, monitor dan cakera keras luaran anda ke soket ini. Peranti ini akan menerima kuasa daripada bateri UPS semasa gangguan bekalan elektrik.tage.
- Outlet Dilindungi Lonjakan: Connect non-critical equipment that still requires surge protection, such as printers or scanners, to these outlets. These devices will not receive battery backup power.
- Port Caj USB: Use the front USB-A and USB-C ports to charge mobile phones, MP3 players, and cameras.
- Perlindungan Talian Data: Connect your network cable (RJ45) and coaxial cable (Coax) through the designated IN/OUT ports on the rear panel to protect against surges.
6. Arahan Operasi
6.1 Menghidupkan/Mematikan UPS
- Untuk Menghidupkan: Press and hold the Power button on the front panel for approximately 2 seconds. The LCD display will light up.
- Untuk Mematikan: Press and hold the Power button for approximately 2 seconds. The LCD display will turn off.
6.2 Fungsi Paparan LCD
The multifunction LCD panel displays immediate, detailed information on battery and power conditions. Use the 'Display' button to cycle through various screens:
Gambar 4: Cthamples of information displayed on the Intelligent LCD panel, including input/output voltage, beban dan status bateri.
- Input Voltage: Menunjukkan vol semasatage from the utility power.
- Keluaran Voltage: Menunjukkan voltage supplied by the UPS to connected equipment.
- Kapasiti Bateri: Indicates the current charge level of the internal batteries.
- Kapasiti Muatan: Memaparkan peratusantage of the UPS's capacity being used by connected equipment.
- Anggaran Masa Larian: Provides an estimate of how long the UPS can supply power during an outage based on the current load.
- Log Acara: Records power events such as outages, lonjakan, dan voltage turun naik.
6.3 Vol. Automatiktage Peraturan (AVR)
UPS mempunyai Voltan Automatiktage Regulation (AVR), which automatically corrects minor power fluctuations (sags and overvoltages) without switching to battery power. This extends the life of the battery by reducing the number of times it needs to discharge and recharge.
6.4 PowerPanel Personal Edition Management Software
The UPS comes with FREE PowerPanel Personal Edition Management Software (Download). This software allows for advanced power management features, including scheduled shutdowns, remote monitoring, and customizable alerts. Refer to the software's documentation for installation and usage instructions.
7. Penyelenggaraan
7.1 Penggantian Bateri
The CyberPower BRG1500AVRLCD uses two 12V batteries. The batteries are designed to last approximately 3-5 years under normal operating conditions. When the batteries reach the end of their service life, they should be replaced by qualified personnel. For battery replacement, contact CyberPower Systems customer support or a certified technician.
7.2 Pembersihan
Regularly clean the exterior of the UPS with a dry cloth. Ensure ventilation openings are free from dust and debris to maintain proper airflow and prevent overheating.
8. Penyelesaian masalah
If the UPS is not functioning correctly, refer to the following common issues:
- UPS tidak boleh dihidupkan: Ensure the power cord is securely plugged into a grounded wall outlet and the UPS. Check the circuit breaker on the rear panel and reset if tripped.
- UPS berbunyi bip berterusan: This usually indicates the UPS is operating on battery power during an outage or a low battery condition. Save your work and shut down connected equipment if the outage dipanjangkan.