Green Valley 935110 Xtragrip N°110 Snow Chains User Manual

1. Pengenalan

The Green Valley 935110 Xtragrip N°110 Snow Chains are designed to provide enhanced traction for vehicles in snowy and icy conditions. These chains are constructed from treated alloy steel, featuring a 9mm link thickness, and are TUV certified for quality and safety. Proper installation and adherence to safety guidelines are crucial for effective performance and vehicle safety.

2. Maklumat Keselamatan

• Always read and understand these instructions completely before installing or using snow chains.
• Install chains on the drive wheels of your vehicle. For 4x4 vehicles, consult your vehicle's owner's manual for specific recommendations.
• Do not exceed 30 mph (50 km/h) when snow chains are installed.
• Avoid sudden acceleration, braking, or sharp turns, as this can damage the chains or your tires.
• Check chain tension after driving a short distance (approximately 1/4 mile or 400 meters) and re-tension if necessary.
• Remove chains immediately when driving on clear pavement to prevent damage to the chains, tires, and road surface.
• Ensure adequate clearance between the chains and vehicle components (e.g., fenders, brake lines).
• Wear protective gloves during installation and removal to prevent injury.

3. Kandungan Pakej

Your Green Valley 935110 Xtragrip N°110 Snow Chains package should contain:

• Two (2) Green Valley 935110 Xtragrip N°110 Snow Chains
• Satu (1) Kotak Penyimpanan
• One (1) Pair of Installation Gloves (may vary by package)

4. Persediaan dan Pemasangan

Before installation, ensure your vehicle is parked on a level surface, the parking brake is engaged, and the engine is off. It is recommended to practice installation in a safe environment before encountering adverse weather conditions.

1. Lay Out Chains: Lay the snow chain flat on the ground in front of the tire, ensuring there are no twists or tangles. The colored connection points should be visible and accessible.
2. Position Chain: Drape the chain over the top of the tire, ensuring the inner cable (often with a colored connector) is behind the tire and the main chain pattern covers the tire tread.
3. Connect Inner Cable: Reach behind the tire and connect the two ends of the inner cable. This may require moving the vehicle slightly forward or backward to gain access.
4. Connect Outer Chain: Bring the outer chain sections together and connect them. Follow the specific connection method for your Xtragrip N°110 chains, which typically involves hooks and tensioning levers.
5. Tension Chains: Use the integrated tensioning system to tighten the chains securely around the tire. The chains should be snug but not excessively tight. Refer to the specific tensioning mechanism of the Xtragrip N°110 model.
6. Semak Kelegaan: Rotate the tire slowly by hand to ensure there is no interference with brake lines, suspension components, or fenders.
7. Drive and Re-tension: Drive a short distance (approximately 1/4 mile or 400 meters) at a low speed (5-10 mph) and then stop to re-check the chain tension. Re-tension if necessary, as chains can loosen slightly after initial use.

Figure 1: Green Valley Xtragrip N°110 snow chain correctly installed on a vehicle tire. This image demonstrates the pattern of the chains across the tread and the attachment points around the wheel.

5. Arahan Operasi

• Had Kelajuan: Never exceed 30 mph (50 km/h) when snow chains are installed.
• Gaya Pemanduan: Drive smoothly. Avoid sudden acceleration, hard braking, or abrupt steering maneuvers.
• Keadaan jalan raya: Use chains only on snow or ice-covered roads. Remove them immediately when conditions improve to prevent damage to the chains, tires, and road.
• Bunyi dan Getaran: Some noise and vibration are normal when driving with snow chains. Excessive noise or vibration may indicate improper installation or damage. Stop and inspect the chains if this occurs.

6. Penyelenggaraan

• Pembersihan: After each use, rinse the snow chains thoroughly with fresh water to remove salt, dirt, and debris.
• Pengeringan: Allow the chains to air dry completely before storing them. This prevents rust and extends their lifespan.
• Pemeriksaan: Before and after each use, inspect the chains for any signs of wear, damage, or broken links. Replace damaged chains immediately.
• Storan: Store the clean, dry chains in their original storage case in a cool, dry place, away from direct sunlight and chemicals.

7. Penyelesaian masalah

• Chains feel loose after driving: This is common. Stop and re-tension the chains as described in the "Setup and Installation" section.
• Bunyi atau getaran yang berlebihan: Stop immediately and inspect the chains. Ensure they are properly installed, tensioned, and not tangled or damaged.
• Chain breakage: If a chain link breaks, remove the chain immediately to prevent damage to your vehicle. Do not attempt to repair and reuse a broken chain.
• Kesukaran memasang: Ensure the chains are untangled and laid out correctly. If the tire is stuck in snow, try to clear some snow around it or move the vehicle slightly.

8. Spesifikasi

9. Waranti dan Sokongan

For warranty information or technical support regarding your Green Valley 935110 Xtragrip N°110 Snow Chains, please refer to the documentation included with your purchase or contact Green Valley customer service directly. Keep your proof of purchase for warranty claims.