Manual Pengguna Acuan Tiang-B Chrysler Tulen 5020664AC

pengenalan

This manual provides essential information for the proper installation, maintenance, and care of your Chrysler Genuine 5020664AC B-Pillar Molding. Please read this manual thoroughly before beginning installation to ensure correct procedure and optimal performance.

Maklumat Keselamatan

Always exercise caution when working with automotive parts. Wear appropriate personal protective equipment (PPE) such as gloves and eye protection. Ensure the vehicle is stable and secure before beginning any work. Keep small parts away from children.

Kandungan Pakej

Sahkan bahawa semua komponen ada dan tidak rosak semasa membuka bungkusan.

• 1 x Chrysler Genuine 5020664AC B-Pillar Molding

Rajah 1: Depan view of the B-Pillar Molding, showing its overall shape and finish.

Arahan Pemasangan

This B-Pillar Molding is designed for direct replacement or installation on the vehicle's B-pillar surface. Proper surface preparation is crucial for secure adhesion.

1. Sediakan Permukaan: Thoroughly clean the B-pillar surface where the molding will be applied. Use an automotive-grade degreaser or alcohol wipe to remove any dirt, wax, or grease. Allow the surface to dry completely.
2. Ujian Kesesuaian: Before removing the adhesive backing, carefully position the molding on the B-pillar to ensure it aligns correctly. Note the exact placement.
3. Apply Adhesive (Optional, Recommended): For enhanced adhesion, a thin layer of automotive-grade adhesive (e.g., strong automotive adhesive) can be applied to the back of the molding, avoiding the pre-applied adhesive strips. This step is optional but recommended for a more solid bond.
4. Keluarkan Sandaran Pelekat: Carefully peel off the protective film from the adhesive strips on the back of the molding. It is critical not to remove the adhesive tape until the piece is ready for final installation.
5. Install the Molding: Align the molding with the prepared B-pillar surface and firmly press it into place. Apply even pressure along the entire length of the molding to ensure full contact with the adhesive. Hold pressure for several minutes.
6. Masa Pengawetan: Allow the adhesive to cure for at least 24 hours before exposing the vehicle to extreme weather conditions or car washes. Refer to the adhesive manufacturer's instructions if an additional adhesive was used.

Rajah 2: Belakang view of the B-Pillar Molding, highlighting the pre-applied adhesive strips for installation.

Penyelenggaraan

The B-Pillar Molding requires minimal maintenance. Regularly clean the surface with standard automotive cleaning products. Avoid abrasive cleaners or harsh chemicals that could damage the finish or adhesive bond.

Menyelesaikan masalah

• Molding not adhering properly: Ensure the surface was thoroughly cleaned and dry before installation. Temperature can affect adhesive performance; install in moderate temperatures. Re-apply with a stronger automotive adhesive if necessary.
• Molding appears misaligned: This typically occurs during initial placement. If the adhesive has not fully cured, it may be possible to carefully reposition. If fully cured, removal may damage the molding or vehicle surface.

Spesifikasi

Waranti dan Sokongan

For warranty information or technical support regarding your Chrysler Genuine 5020664AC B-Pillar Molding, please contact Chrysler customer service or refer to the official Chrysler webtapak. Simpan resit pembelian anda sebagai bukti pembelian.

Visit the official Chrysler store for more information: Kedai Chrysler