Kes 320

Manual Servis Backhoe Pemuat Traktor Case 320

Essential guide for maintenance, repair, and diagnostics.

1. Pengenalan

This service manual provides detailed information for the maintenance, repair, and troubleshooting of the Case 320 Tractor Loader Backhoe (TLB). It is intended for qualified service personnel and technicians. Adherence to the procedures outlined in this manual is crucial for ensuring the safe and efficient operation and longevity of the equipment.

The manual is organized into sections covering various aspects of the TLB, including safety, component descriptions, preventative maintenance schedules, diagnostic procedures, and technical specifications. Always refer to the latest version of this manual for the most accurate information.

2. Maklumat Keselamatan

Safety is paramount when working with heavy machinery. Always observe the following general safety precautions to prevent injury to personnel or damage to the equipment.

  • Baca dan Fahami: Before performing any service or maintenance, thoroughly read and understand all instructions and warnings in this manual and on the machine itself.
  • Alat Pelindung Diri (PPE): Always wear appropriate PPE, including safety glasses, gloves, hard hat, and steel-toed boots.
  • kunci keluar/Tagkeluar: Ensure the machine is properly shut down, parked on level ground, and all attachments are lowered. Disconnect the battery and apply lockout/tagout procedures before working on electrical systems or moving parts.
  • Tekanan Hidraulik: Relieve all hydraulic pressure before disconnecting hydraulic lines or components. Hydraulic fluid under pressure can cause severe injury.
  • Hot Surfaces/Fluids: Be aware of hot engine components, exhaust systems, and fluids (oil, coolant) which can cause burns. Allow the machine to cool before servicing.
  • Alat yang Betul: Use only the correct tools for the job. Ensure tools are in good condition.
  • Kebersihan: Keep the work area clean and free of clutter. Spills can lead to slips and falls.

3. Komponen Lebihview

The Case 320 TLB is comprised of several key systems working in conjunction. Understanding the basic function and location of these components is essential for effective servicing.

Cover of a J.I. Case Service Manual for various tractor, crawler, forklift, and TLB models, including 210B, 310, 430, and 530 series.

Figure 3.1: Representative cover of a J.I. Case Service Manual. While this specific cover details models such as 210B, 310, 430, and 530 series, it illustrates the typical format and appearance of service documentation for Case heavy equipment. This manual provides comprehensive service information for the Case 320 Tractor Loader Backhoe.

  • Sistem Enjin: Powers the machine and its hydraulic systems. Includes fuel, cooling, lubrication, and exhaust sub-systems.
  • Sistem Hidraulik: Provides power for the loader, backhoe, steering, and other hydraulic functions. Consists of pumps, valves, cylinders, and reservoirs.
  • Kereta api: Transmits power from the engine to the wheels, including the transmission, axles, and differential.
  • Loader Assembly: Front-mounted attachment for digging, lifting, and carrying materials.
  • Backhoe Assembly: Rear-mounted attachment for excavation and trenching.
  • Sistem Elektrik: Controls engine starting, lighting, instrumentation, and various electronic components.

4. Penyelenggaraan Pencegahan

Regular preventative maintenance is critical for the reliable operation and extended lifespan of your Case 320 TLB. Follow the recommended service intervals and procedures.

4.1 Daily Checks (Before Operation)

  • Periksa paras minyak enjin.
  • Periksa paras bahan penyejuk.
  • Verify hydraulic fluid level.
  • Periksa tekanan dan keadaan tayar.
  • Inspect all hoses and lines for leaks or damage.
  • Test all lights, gauges, and safety devices.
  • Clean windows and mirrors.

4.2 Scheduled Maintenance (Every 250 Hours / Monthly)

  • Tukar minyak enjin dan penapis.
  • Inspect air filter elements.
  • Lubricate all grease points on loader and backhoe linkages.
  • Periksa paras elektrolit dan terminal bateri.
  • Inspect fan belt tension and condition.

4.3 Scheduled Maintenance (Every 500 Hours / Quarterly)

  • Replace fuel filters.
  • Change hydraulic filter.
  • Inspect and adjust brake pedal free play.
  • Check transmission fluid level and condition.

Refer to the detailed maintenance schedule within the full service manual for comprehensive instructions and additional intervals.

5. Troubleshooting & Diagnostics

This section provides a guide to common issues that may arise with the Case 320 TLB and outlines basic diagnostic steps. For complex problems, consult a qualified technician or the detailed diagnostic charts in the complete service manual.

simptomKemungkinan PuncaTindakan Pembetulan
Enjin Gagal DimulakanLow battery charge, fuel system issue, starter motor fault.Check battery connections and charge, verify fuel supply, inspect starter.
Kehilangan Kuasa HidraulikLow hydraulic fluid, clogged filter, faulty pump, relief valve issue.Check fluid level, replace filter, inspect pump/valves.
Enjin Terlalu PanasPenyejuk rendah, radiator tersumbat, termostat rosak, masalah tali sawat kipas.Check coolant, clean radiator, test thermostat, inspect fan belt.
Poor Braking PerformanceWorn brake pads, air in hydraulic lines, low brake fluid.Inspect pads, bleed brake system, check fluid level.

6. Spesifikasi Teknikal

The following are general technical specifications for the Case 320 Tractor Loader Backhoe. Specific values may vary based on configuration and year of manufacture. Always refer to the machine's data plate for precise information.

  • Jenis Enjin: Diesel, 4-cylinder (Specific model details in full manual)
  • Berat Operasi: Approximately 14,000 - 16,000 lbs (6,350 - 7,250 kg)
  • Loader Bucket Capacity: 0.75 - 1.0 cu yd (0.57 - 0.76 cu m)
  • Backhoe Digging Depth: 14 - 16 ft (4.2 - 4.8 m)
  • Kapasiti Tangki Bahan Api: Approximately 30 - 40 US gallons (113 - 151 liters)
  • Hydraulic System Capacity: Approximately 20 - 25 US gallons (75 - 95 liters)

7. Support & Ordering Information

For additional support, genuine replacement parts, or to order supplementary manuals, please contact the publisher or an authorized Case dealer.

This manual is published by Jensales. When ordering parts, always provide the full model number and serial number of your Case 320 TLB to ensure compatibility.

Note: This document is a general guide. For comprehensive repair procedures, detailed schematics, and specific part numbers, refer to the complete official Case 320 Service Manual.

Dokumen Berkaitan - 320

Praview Manual Pengendali Jengkaut Pemuat King Pembinaan CASE 580E & 580S | JI Case
Manual pengendali yang komprehensif untuk Backhoe Pemuat King Pembinaan CASE 580E dan 580S. Meliputi keselamatan, operasi, penyelenggaraan dan spesifikasi. Disediakan oleh JI Case.
Praview Manual Servis Backhoe Super E Loader Case 580
Manual servis komprehensif untuk Backhoe Pemuat Case 580 Super E, meliputi penyelenggaraan, penyelesaian masalah dan spesifikasi untuk semua sistem utama termasuk enjin, bahan api, elektrik, brek, hidraulik dan power train.
Praview Bilah Dozer Pengorek CASE CX80C - Spesifikasi dan Prestasi
Spesifikasi terperinci, data prestasi dan kapasiti angkat untuk Pengorek CASE CX80C dengan Bilah Dozer, Diperakui Akhir Tahap 4. Termasuk enjin, rangkaian pacuan, hidraulik, persekitaran pengendali, dimensi dan butiran peralatan.
Praview CASE CX80 Hydraulic Excavator: Spesifikasi dan Ciri
Terokai penggali hidraulik CASE CX80, mesin berkuasa dan serba boleh direka untuk pelbagai kerja pembinaan dan tapak. Dokumen ini memperincikan enjin, sistem hidraulik, keselesaan teksi, bahagian bawah pengangkutan, lampiran, data prestasi, dimensi dan peralatan standard/pilihan.
Praview Spesifikasi dan Data Pemuat Roda Artikulasi CASE 621D/XT/XR
Spesifikasi terperinci, dimensi, data prestasi dan maklumat peralatan untuk pemuat roda artikulasi CASE 621D, 621XT dan 621XR.
Praview CASE TV450B Compact Track Loader - Spesifikasi Akhir Tahap 4
Spesifikasi terperinci untuk CASE TV450B Compact Track Loader, termasuk enjin, pacuan, hidraulik, dimensi, kapasiti dan data prestasi. Peringkat 4 Akhir diperakui.