Advantage Controls Mega Tron Controller Instructions

Advantage Controls Mega Tron Controller

Berakhirview

The MegaTron controller supports BACnet communications with Building Management Systems and WebAdvantage. BACnet uses an object-oriented model so systems can interoperate over shared networks to exchange control/status functions.

Conformance & Object Support

• Versi Perisian Aplikasi: JA.16.0 and higher
• Semakan Perisian Tegar: JA.16.0 and higher
• Semakan Protokol BACnet: 24
• BACnet Standardized Device Profile (Lampiran L): Pengawal Khusus Aplikasi BACnet (B-ASC)
• Blok Bangunan Saling Operasi BACnet Disokong (Lampiran K): DS-RP-B, DM-DDB-B, DM-DCC-B, DM-RD-B
• Pilihan Lapisan Pautan Data: BACnet IP (Annex J)
• Character Set Supported: ANSI X3.4

Object/property support matrix: “See table 1-1 Object/Property Support Matrix.” (The table content is shown as property support markers but is not enumerated as concrete max values in the source excerpt.)

Example object instance summaries (examples shown in source excerpt): Binary Input objects BI-000 to BI-003; Binary Value objects BV-012 to BV-273 (multiple alarm/monitor functions); Analog Input objects AI-000 to at least AI-071 shown; Analog Value objects AV-000 to at least AV-126 shown; Multi-State Value objects MSV-000 to MSV-019 shown.

Langkah Penyediaan Pantas

1. Open setup menus: Tekan Setup/Run, kemudian CONFIGURE, RANGKAIAN, TETAPAN.
2. Select BACnet: Tekan BAC. If options are not visible, enable the dual network card (source note).
3. Enter instance/port: Masukkan ke INSTANCE PERANTI dan PELABUHAN. Tekan Masuk to accept on each.
4. Reset communications card: Tekan TETAP SEMULA, kemudian tekan Masuk to accept; wait for the communications card reset countdown.
5. Reboot controller: After reset, cycle power kepada pengawal.
6. Set device identifier (MegaTron XS): Go to Configure menu → Network settings → BAC and enter the device object identifier. The device object instance number range is 0 hingga 4194303, dan 4194303 is described as “unconfigured” and not a valid device instance number.

Pengenalan BACnet

• Pengawal MegaTron mampu menyambung ke WebAdvantage Pelayan dan kebanyakan Sistem Pengurusan Bangunan. The WebAdvantage service requires a gateway to the internet with firewall and security rules in place. The
• Building Management System needs to be on the same subnet  to properly receive traffic from the MegaTron. This may require some advanced routing of network traffic within the network wiring or programming of advanced switching equipment. The datatraffic for both is provided via the same Ethernet cable coming from the MegaTron.
• Protokol BACnet membolehkan antara muka dengan aplikasi PC yang lebih boleh disesuaikan menggunakan HMI/SCADA dan sistem HMI yang berdiri sendiri

BACnet Selesaiview

• BACnet is an American National Standard. The BACnet protocol allows the creation of an automation and controls system which may interoperate with other BACnet systems. In BACnet terms, interoperate means that two or more
• BACnet-speaking computer systems may share the same communications networks, and ask each other to perform various functions on a peer-to-peer basis.
• Fleksibiliti BACnet mempunyai dua faedah penting: kebebasan vendor dan keserasian ke hadapan dengan sistem generasi akan datang. Ini dicapai menggunakan pendekatan berorientasikan objek untuk mewakili semua maklumat dalam setiap pengawal. Memandangkan BACnet adalah berdasarkan piawaian, ia memberikan faedah maksimum untuk kedua-dua vendor yang mereka bentuk sistem BACnet dan penentu atau pemilik sistem tersebut.

Pelaksanaan Protokol

• Versi Perisian Aplikasi: JA.16.0 dan lebih tinggi
• Semakan Perisian Tegar: JA.16.0 dan lebih tinggi
• Semakan Protokol BACnet: 24
• BACnet Standardized Device Profile (Annex L): BACnet Application Specific Controller (B-ASC) BACnet Interoperability Building Blocks Supported (Annex K):
  • DS-RP-B
  • DM-DDB-B
  • DM-DCC-B
  • DM-RD-B
• Standard Object Types Supported: See table 1-1 “Object/Property Support Matrix”. Data Link Layer Options: BACnet IP, (Annex J)
• Set Aksara Disokong: ANSI X3.4

Menyambung

• Panduan ini direka bentuk untuk membantu menyambungkan MegaTron yang didayakan BACnet kepada BMS tempatan.
• Nota: Skrin mungkin berbeza sedikit antara model.

Persediaan BACnet

• Step 1: Press Setup/Run, CONFIGURE, NETWORK, SETTINGS. (See figures 1, 2, 3 and 4. H26 dual cards add figure 3B. H26 only available for MegaTron MT.)
• Step 2: Press BAC. (See figure 4.) Note: If these options are not visible, the dual network card needs to be enabled. See enabling dual network card to continue setup.
• Step 3: Enter the DEVICE INSTANCE and PORT. Press Enter to accept on each. (See figure 6.)
• Step 4: Press RESET and then press Enter to accept. The communications card will reset after a short countdown. (See figures 7 and 8.)
• Langkah 5: Selepas kad komunikasi telah ditetapkan semula kuasa kitaran kepada pengawal.

Persediaan MegaTron XS

• MegaTron XS akan menjadi "objek peranti" pada rangkaian BACnet tertentu. Setiap objek peranti (MegaTron XS anda) mesti mempunyai pengecam objek yang luas rangkaian unik. Nombor contoh objek peranti biasanya dikonfigurasikan di tapak selepas peranti dipasang. Julat nombor tika objek peranti adalah antara 0 dan 4194303. Ambil perhatian bahawa 4194303 dikenali sebagai "tidak dikonfigurasikan" dan sebenarnya bukan nombor tika peranti yang sah. Semua peranti dikehendaki bertindak balas dengan nombor contoh objek Peranti mereka sendiri apabila 4194303 diminta.
• Untuk memasukkan pengecam objek peranti anda, pergi ke menu Konfigurasi dalam MegaTron XS dan pilih tetapan Rangkaian. Kemudian pilih BAC.

Definisi Objek

• Matriks Sokongan Objek / Harta (Jadual 1-1)

Ringkasan Contoh Objek Input Binari (Jadual 1-2)

Ringkasan Contoh Objek Nilai Perduaan (Jadual 1-3)

Ringkasan Contoh Objek Input Analog (Jadual 1-4)

Ringkasan Contoh Objek Nilai Analog (Jadual 1-5)

Ringkasan Contoh Objek Berbilang Negeri (Jadual 1-6)

Note #1           1=H-OFF        2=H-ON          3=OFF            4=ON

Dapatkan Advantage dalam Peralatan Rawatan Air

Advantage Controls can give you the Advantage in products, knowledge and support on all of your water treatment equipment needs.

• Pengawal Menara Penyejuk
• Pengawal Boiler Blow Down
• Pakej Injap Blow Down
• Injap Solenoid
• Meter Air
• Pam Pemeteran Kimia
• Rak Kupon Kakisan
• Tangki Penyelesaian Kimia
• Sistem Suapan Pepejal
• Pemasa Suapan
• Peralatan Penapis
• Sistem Suapan Glikol
• Sistem Pra-Fabrikasi

Menyelesaikan masalah

• Setup menu options not visible: The manual notes that if the BAC options are not visible, the “dual network card needs to be enabled.”
• After BACnet reset: The manual instructs that after pressing RESET and accepting with Enter, the communications card will reset after a short countdown, and then you must cycle power kepada pengawal.
• Network not receiving traffic from MegaTron: The manual states that the Building Management System needs to be on the same subnet to properly receive traffic from the MegaTron, which may require advanced routing or advanced switching equipment programming.
• WebAdvantage connectivity requirements: Untuk WebAdvantage, the manual states that an internet gateway dengan firewall and security rules in place is required (if you are using WebAdvantage service).