Intex QS400 Crystal Clear Saltwater Pool Chlorine System

pengenalan

Terima kasih kerana membeliasing the Intex QS400 Crystal Clear Saltwater Pool Chlorine System. This system is designed to provide a more natural and pleasant swimming experience by converting ordinary salt into chlorine, eliminating the need for traditional packaged chlorine. Please read this manual thoroughly before installation and operation to ensure proper use and maintenance of your system.

Imej: The Intex QS400 Crystal Clear Saltwater Pool Chlorine System. The main unit is white and grey with the 'INTEX' logo, featuring a control panel on top. To its right, a smaller grey and white power supply unit is connected by a black cable. This system is designed for efficient pool water sanitization.

Maklumat Keselamatan

Always follow basic safety precautions when installing and using this electrical product. Failure to follow these instructions can result in serious injury or death.

• Baca semua arahan sebelum menggunakan produk ini.
• Connect only to a grounded outlet protected by a Ground-Fault Circuit Interrupter (GFCI).
• Do not operate the system if the power cord or plug is damaged.
• Keep children away from the system during operation.
• Ensure the pool pump is running when the saltwater system is operating.
• Maintain proper salt levels as specified in this manual.

Persediaan

Kandungan Pakej:

• Intex QS400 Saltwater System Unit
• Bekalan Kuasa
• Connection Hoses and Clamps
• Test Strips (for salt and chlorine levels)
• Manual Arahan

Langkah Pemasangan:

1. penempatan: Position the saltwater system on a firm, level surface, at least 10 feet (3 meters) from the pool. Ensure it is protected from direct sunlight and rain.
2. Sambungkan ke Pam Penapis: Connect the saltwater system in line with your pool's filter pump. The water should flow from the pool, through the filter pump, then through the saltwater system, and back to the pool. Use the provided hoses and clamps untuk menjamin keselamatan semua sambungan.
3. Add Salt to Pool: Use only pure, non-iodized salt (sodium chloride) with a purity of 99.8% or higher. Refer to the specifications section for recommended salt levels based on your pool volume. Distribute the salt evenly around the pool and allow it to dissolve completely before operating the system.
4. Sambungan Kuasa: Plug the power supply into a grounded GFCI outlet. Ensure all connections are dry before plugging in.

Arahan Operasi

The Intex QS400 system features a full control panel with a display and push buttons for easy operation.

Permulaan permulaan:

1. Ensure the filter pump is running. The saltwater system requires water flow to operate.
2. Tekan butang Kuasa untuk menghidupkan sistem.
3. The display will show the current salt level (if equipped with a sensor) or prompt for initial setup.
4. Select the desired operating mode (6, 10, or 14 hours) using the mode selection buttons. These modes determine the duration of chlorine generation.
5. The system will begin generating chlorine. Monitor the display for any error codes.

Operasi Harian:

The system is designed for automatic daily operation once the cycle time is set. It will automatically turn on and off based on the programmed cycle.

• Regularly test your pool water for chlorine and pH levels using appropriate test strips.
• Adjust the operating time as needed to maintain optimal chlorine levels (1-3 ppm).
• Ensure the filter pump runs concurrently with the saltwater system.

Penyelenggaraan

Cell Cleaning:

The electrolytic cell may accumulate calcium deposits over time, reducing its efficiency. The system will indicate when cleaning is required.

1. Turn off and unplug the system.
2. Disconnect the hoses from the cell.
3. Carefully remove the cell.
4. Soak the cell in a solution of 1 part muriatic acid to 4 parts water until deposits dissolve. Always add acid to water, never water to acid.
5. Rinse thoroughly with clean water and reinstall.

Kimia Air:

• Tahap garam: Maintain salt levels between 2500-3500 ppm (parts per million). Ideal is 3000 ppm. Low salt will reduce chlorine production, high salt can damage the cell.
• Tahap pH: Keep pH between 7.4 and 7.6. Adjust with pH increaser or decreaser as needed.
• Stabilizer (Cyanuric Acid): Use a stabilizer to protect chlorine from UV degradation, especially in outdoor pools. Maintain 30-50 ppm.

Menyelesaikan masalah

Spesifikasi

• model: Intex QS400 (Model Number: 26664GS)
• Jenama: Intex Recreation Corp.
• Voltage: 12 Volt (AC)
• Kelantangan Kolam Maks: Up to 17,413 liters (4,600 gallons)
• Bahan: PVC Plastic 1.3 mm
• Dimensi: 32.4 x 25.1 x 43.8 cm (12.76 x 9.88 x 17.24 inci)
• Berat: 3.2 kg (7.05 lbs)
• Self-cleaning Modes: 6, 10, 14 hours cycles
• ciri-ciri: Full control panel with display and push buttons, Electro-catalytic oxidation process.

Waranti dan Sokongan

For warranty information and customer support, please refer to the warranty card included with your product or visit the official Intex webtapak. Simpan resit pembelian anda sebagai bukti pembelian untuk tuntutan waranti.

Pengeluar: Intex Recreation Corp.

Hubungi: Sila layari www.intexcorp.com/support/ for the latest support information and contact details.