TCE Torin Steel Jack Stand TCE44008: 4 Ton Capacity Instruction Manual

1. Maklumat Keselamatan

WARNING: Read and understand all instructions before operating this device. Failure to follow these instructions may result in serious injury or property damage.

• Always use jack stands in pairs on hard, level surfaces.
• Ensure the load is centered on the saddle of the jack stand.
• Do not exceed the rated capacity of 4 tons (8,000 lbs) per stand.
• Jack stands are designed to support a vehicle; they are not intended for lifting.
• Never make alterations to the jack stand.
• Always use additional safety measures, such as wheel chocks, when working under a vehicle.
• This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm (California Proposition 65 Warning).

2. Produk Lebihview

Figure 1: A single blue TCE Torin Steel Jack Stand, model TCE44008, with a 4-ton capacity label visible on its side. The stand features a sturdy pyramidal base and an adjustable ratchet bar.

Ciri-ciri Utama:

• One-piece multi-position ductile ratchet bar for strength and durability.
• Quick adjustment mechanism securely locks into desired height.
• Sturdy welded steel construction with a forged ratchet bar for longevity, safety, and strength.
• Designed to prevent distortion from repetitive use.

3. Persediaan dan Operasi

Persediaan Awal:

1. Ensure the jack stands are placed on a firm, level surface.
2. Position the jack stands under the vehicle's designated support points, as specified by the vehicle manufacturer.

Menyelaraskan Tinggi:

1. To raise the jack stand, lift the handle to disengage the locking mechanism.
2. Extend the ratchet bar to the desired height.
3. Release the handle, ensuring the ratchet bar securely locks into one of the notches.
4. To lower the jack stand, lift the handle and carefully lower the ratchet bar.

4. Penyelenggaraan

• Inspect jack stands before each use for any signs of damage, wear, or corrosion.
• Clean the jack stands regularly to remove dirt, grease, and debris.
• Store in a dry, clean area to prevent rust and extend product life.
• Do not use if any part is damaged or bent.

5. Penyelesaian masalah

• Jack stand not locking: Ensure the ratchet bar is fully extended and the handle is released, allowing the locking mechanism to engage properly with a notch. Check for any obstructions.
• Ketidakstabilan: Verify that the jack stands are placed on a firm, level surface and that the vehicle's weight is evenly distributed and centered on the saddle.
• Difficulty adjusting: Clean any debris from the ratchet mechanism. If the issue persists, inspect for damage.

6. Spesifikasi

7. Waranti dan Sokongan

For warranty information or technical support, please refer to the product packaging or contact TCE customer service directly. Keep your purchase receipt for any warranty claims.