Westek TMSW15MI Hardwire Indoor In-Wall 15 Minute Mechanical Countdown Timer

pengenalan

The Westek TMSW15MI is a hardwire indoor in-wall mechanical countdown timer designed to automatically turn off lights and motors after a selected time, up to 15 minutes. This device replaces a standard single-pole, single-throw wall switch, providing convenient timed control for various electrical loads.

Imej: Depan view of the Westek TMSW15MI In-Wall Mechanical Countdown Timer, showing the ivory finish and the twist knob for setting the countdown time.

Maklumat Keselamatan

WARNING: RISK OF ELECTRIC SHOCK. Improper installation can result in serious injury or death. Always consult a qualified electrician if you are unsure about any part of the installation process.

• MATIKAN KUASA at the circuit breaker or fuse box before installing or servicing the timer.
• Verify that power is off before proceeding with installation.
• This timer is for kegunaan dalaman sahaja.
• Jangan melebihi penarafan elektrik maksimum peranti.
• Pastikan semua sambungan wayar selamat dan terlindung dengan betul.
• This device must be installed in accordance with all national and local electrical codes.

Kandungan Pakej

• 1 x Westek TMSW15MI In-Wall Mechanical Countdown Timer
• Skru Pemasangan
• Wire Nuts (typically included, but may vary)
• Lembaran Arahan

Spesifikasi

Pemasangan

Replacing an Existing Wall Switch

1. Matikan kuasa: Locate the circuit breaker or fuse that controls the switch you are replacing and turn it OFF. Verify the power is off by attempting to operate the switch or using a voltage penguji.
2. Remove wall plate: Unscrew and remove the existing wall plate.
3. Remove old switch: Unscrew the old switch from the electrical box and carefully pull it out.
4. Disconnect wires: Note the wiring configuration of the old switch. Typically, there will be two load/line wires connected to the switch and a ground wire. Disconnect these wires.
5. Connect new timer: The Westek TMSW15MI timer has screw terminals. Connect the two load/line wires from the electrical box to the two terminals on the timer. If a ground wire is present in the box, connect it to the green ground screw on the timer (if available) or to the box's ground. Ensure all connections are tight and secure.
6. Mount timer: Carefully push the wired timer back into the electrical box. Secure it with the provided mounting screws.
7. Install wall plate: Attach the new or existing wall plate over the timer.
8. Pulihkan kuasa: Hidupkan semula kuasa pada pemutus litar atau kotak fius.

Penting: This timer is designed for single-pole applications only. Do not attempt to install it in a 3-way or 4-way switch configuration unless you are certain of the wiring and have consulted a qualified electrician.

Arahan Operasi

The Westek TMSW15MI mechanical countdown timer is simple to operate:

1. Untuk mengaktifkan pemasa: Rotate the knob clockwise to the desired countdown time (up to 15 minutes).
2. The connected device (light, motor, etc.) will turn ON immediately.
3. Pemasa akan mula mengira detik.
4. Once the set time has elapsed, the timer will automatically turn OFF the connected device by breaking the electrical circuit.
5. To turn the device ON again, simply rotate the knob to the desired time.

Penyelenggaraan

• Pembersihan: To clean the timer, wipe the surface with a soft, damp kain. Jangan gunakan pembersih atau pelarut yang melelas. Pastikan kuasa dimatikan sebelum membersihkan.
• No user-serviceable parts: The internal mechanism of the timer contains no user-serviceable parts. Do not attempt to open or repair the unit.

Menyelesaikan masalah

• Timer does not turn ON:
  • Periksa sama ada pemutus litar ON.
  • Pastikan semua sambungan wayar selamat.
  • Verify the load is within the timer's electrical ratings.
• Timer does not turn OFF:
  • Ensure the knob is set to a specific time and not stuck.
  • The internal mechanism may be faulty. If so, the unit may need replacement.
• Timer makes a ticking sound:
  • This is normal for mechanical timers as the internal gears operate.

Waranti

This Westek product is covered by a Waranti Terhad 1 Tahun from the date of purchase. This warranty covers defects in materials and workmanship under normal use. It does not cover damage resulting from misuse, abuse, improper installation, or unauthorized repairs. For warranty service, please retain your proof of purchase and contact Westek customer support.

Sokongan Pelanggan

For further assistance, technical support, or warranty inquiries, please visit the official Westek website or contact their customer service department. Refer to the packaging or the Westek webtapak untuk maklumat hubungan terkini.

Westek Official Webtapak: Visit the Westek Store on Amazon