The Elkay Space-ette Cooler (Model FD7003L1Z) is a self-contained, electric refrigerated floor model water cooler designed for installations with limited space. It features a slim profile and a durable vinyl clad finish. The unit provides chilled water through a hermetically sealed refrigeration system and is rated for indoor use.
Rajah 1: Depan view of the Elkay FD7003L1Z Space-ette Cooler.
Ciri-ciri Utama:
Traditional small footprint floor mount design for space-saving installations.
Hermetically sealed refrigeration system for chilled water.
Durable and attractive vinyl clad finish.
Mechanical top bubbler button for water dispensing.
Rated for indoor use.
Persediaan dan Pemasangan
This section provides general guidelines for setting up your Elkay Space-ette Cooler. Professional installation by a qualified plumber and electrician is recommended to ensure proper function and safety.
1. Membongkar:
Keluarkan penyejuk dari bungkusannya dengan berhati-hati.
Periksa unit tersebut untuk sebarang kerosakan penghantaran. Laporkan sebarang kerosakan kepada pembekal anda dengan segera.
Pastikan semua komponen ada.
2. Pemilihan Lokasi:
Choose a level, stable surface for placement. The unit is designed for floor mounting.
Ensure adequate clearance around the unit for ventilation, especially at the rear and sides where the refrigeration system is located.
The cooler is rated for indoor use only. Avoid direct sunlight or placement near heat sources.
The cabinet design allows for flush-to-wall installation, but ensure access for maintenance and connections.
Figure 2: Dimensions of the Elkay FD7003L1Z Space-ette Cooler.
3. Sambungan Bekalan Air:
Connect the unit to a potable cold water supply line.
Install a shut-off valve in the water supply line for easy maintenance.
Pastikan semua sambungan selamat dan bebas bocor.
4. Sambungan Longkang:
Connect the cooler's drain line to an appropriate waste receptor or floor drain.
Ensure proper slope for drainage and prevent standing water.
5. Sambungan Elektrik:
The unit operates on standard household electrical power (Corded Electric).
Palamkan kord kuasa ke salur keluar elektrik yang dibumikan dengan betul.
Jangan gunakan kord sambungan.
Ensure the electrical supply matches the unit's requirements (refer to the product label for specific voltage dan amppemadam).
Arahan Operasi
Once properly installed and connected, your Elkay Space-ette Cooler is ready for use.
1. Initial Start-up:
After connecting water and power, allow the unit to run for approximately 30 minutes to chill the water.
Dispense a small amount of water to flush any air from the lines.
2. Dispensing Water (Bubbler):
To dispense water, press the mechanical top bubbler button located on the top surface of the cooler.
Lepaskan butang untuk menghentikan aliran air.
3. Adjusting Water Temperature:
The refrigeration system is factory-set for optimal cooling. If temperature adjustment is needed, consult a qualified service technician.
Penyelenggaraan
Regular maintenance ensures the longevity and hygienic operation of your water cooler.
1. Cleaning the Exterior:
Wipe down the vinyl clad exterior with a soft, damp kain dan sabun lembut.
Elakkan pembersih atau pelarut yang melelas yang boleh merosakkan kemasan.
For the stainless steel top, use a stainless steel cleaner and polish in the direction of the grain.
2. Cleaning the Bubbler and Basin:
Regularly clean the bubbler head and the basin area with a mild disinfectant solution.
Ensure the drain is clear of any debris to prevent water accumulation.
3. Condenser Coil Cleaning:
Periodically clean the condenser coils (typically located at the rear or bottom of the unit) to ensure efficient cooling.
Disconnect power before cleaning. Use a brush or vacuum cleaner to remove dust and lint.
4. Leak Inspection:
Regularly check all water connections for leaks. Tighten any loose fittings.
Menyelesaikan masalah
This section addresses common issues you might encounter with your water cooler.
1. No Water Flow:
Periksa Bekalan Air: Pastikan injap bekalan air terbuka.
Periksa Kekusutan: Inspect the water lines for any kinks or blockages.
Kuasa: Verify the unit is plugged in and receiving power.
2. Water Not Cold:
Kuasa: Ensure the unit is plugged in and receiving power.
Pengudaraan: Check that the condenser coils are clean and not obstructed, allowing for proper airflow.
Suhu Ambien: The unit's cooling efficiency can be affected by high ambient temperatures.
Penyejukan Awal: Allow sufficient time (at least 30 minutes) for the water to chill after initial setup or power restoration.
3. Leaks:
Sambungan: Inspect all water inlet and drain connections for tightness.
Drain Blockage: Ensure the drain is not clogged, causing water to overflow.
4. Unusual Noise:
Permukaan Aras: Ensure the unit is on a level surface to prevent vibrations.
Kipas: A fan noise is normal during cooling cycles. If the noise is excessive or unusual, contact support.
If these troubleshooting steps do not resolve the issue, please contact Elkay customer support or a qualified service technician.
Spesifikasi
Ciri
Perincian
Nombor Model
FD7003L1Z
Jenama
Elkay
warna
Light Gray Granite
bahan
Vinyl
Kapasiti
3 GPH (Gelen Sejam)
Dimensi Produk (D x W x H)
12"D x 12"W x 38"H
Jenis Pemasangan
Lantai dipasang
Sumber Kuasa
Elektrik Bertali
Wattage
1312.5 watt
Berat Barang
51 paun
Akses Lokasi
Top-reservoir
Waranti dan Sokongan
Maklumat Waranti:
The Elkay FD7003L1Z Space-ette Cooler comes with a Waranti Terhad. For specific details regarding coverage, duration, and terms, please refer to the warranty documentation included with your product or visit the official Elkay webtapak.
Sokongan Pelanggan:
For technical assistance, service, or warranty claims, please contact Elkay customer support. Contact information can typically be found on the manufacturer's webtapak atau dalam pembungkusan produk.
When contacting support, please have your model number (FD7003L1Z) and serial number (if applicable) ready.
Ask a question about this manual
Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.